A6 version
10.2 Installation
1. Open the package, take out
accessories, and open the lock
by turning the key clockwise.
2. Take apart it, and open the
location holes marked on the base.
3. Locate the base where needs to
install, mark the 5 opened holes in
order to fix them.
Attention: Screw NO ②
,④,⑤ or ①,③,④,⑤ are needed only when installation.
The interpretation and ownership of this manual belong to Hiland company. Any change of the
product can be without prior notice.
4. Punch 5 holes of ø6mm in the
to fix the base.
6. Install the cover and turn the key
anticlockwise, then remove the key.
To Previous Page
Loading...