“CO” SHOULD BE ON THE DISPLAY SCREEN
Restart ABPM
“co” on the display indicates the ABPM 7100 is in communication mode,
this can only be accomplished by powering up the device while the
interface cable is connected to the ABPM.
The device will automatically enter communication mode if you start it
up with the interface cable connected. So plugging in the cable after
the device has been switched on will not work, first plug in the cable,
then switch on the device, after start up, the display should say “co”.
Still no “co”
If after restarting the ABPM with the cable connected there’s still no “co”
on the display, you will need to have the device (and the cable)
checked by Welch Allyn.
4
START-UP
xxxxxx rev 1 DD-MM-YYYY © 20XX Hill-Rom Services, Inc. ALL RIGHTS RESERVED.
To Next Page
Loading...
Need help?
General
