Need help?Do you have a question about the Hills NX-1508 and is the answer not in the manual?
Indicates AC power status; flashes for low battery condition.
Indicates armed status; flashes for previous alarm.
Indicates Partial Mode arming; delays bypassed zones.
Indicates fire alarm or trouble condition.
A tab for identifying zones on the code pad.
Indicates zone status: bypass, fault, or service.
Indicates system readiness for arming or force arming.
Indicates a system trouble condition requiring service.
Keys that perform various user-defined functions.
Numeric keys for entering codes and commands.
Keys for activating emergency functions like fire or panic.
Defines an individual's access level on the alarm panel.
Location where alarm data is transmitted during an alarm report.
Sounds a ding-dong when an entry/exit door is opened.
User or Function Codes for system operation, 4 or 6 digits.
Allows a delay in reporting to the central station.
Sends a special code indicating operation under duress.
Allows arming with open zones; ready light flashes.
4 or 6 digit code programmed by installer for device operation.
PIN code to arm/disarm and manage user PIN codes.
Arms perimeter and unused areas while user is inside.
Outer edge of protected area with sensors, typically doors/windows.
Arms system via [ON] or [PARTIAL] key without a user code.
Automatically arms in Full or Partial mode based on exit behavior.
4 or 6 digit entry used to arm or disarm the system.
Indicates armed status; flashes for previous alarm.
Indicates if any zone is bypassed; illuminates bypassed zones.
Indicates if the chime feature is active.
Indicates exit delay; flashes during the last 10 seconds.
Steady for fire fault, flashing for fire trouble.
Indicates system is armed.
Indicates Partial Mode arming; delays bypassed zones.
Indicates primary power is on; flashes for low battery.
Indicates system readiness; flashes for force arm.
Indicates zone bypass, alarm, fault, or trouble condition.
Steps to arm the system for full interior protection while away.
Steps to arm the system using the [ON] key without a user code.
Steps to arm perimeter protection while user is inside.
Procedure to disarm the system using a valid user code.
Steps to temporarily exclude specific zones from protection.
Steps to bypass all designated group bypass zones simultaneously.
Procedure for modifying or creating new user codes.
Steps to remove existing user codes from the system.
Procedure to test sensor functionality and zone activation.
Assigning master code status to user codes for system management.
Turning the chime feature on or off for entry alerts.
Using the [Exit] key to restart the exit timer.
Activating fire, medical, or police/duress alarms.
Viewing zones that were in alarm or bypassed during the last event.
Clearing smoke detector, zone trouble, and tamper alarms.
Procedure to configure the current date on the system.
Procedure to configure the current time on the system.
Customizing the sounder tone frequency for the code pad.
Entering or changing system phone numbers for alarm reporting.
Checking the phone numbers stored in the security system.
Procedure to stop the system from calling programmed numbers.
Removing previously programmed phone numbers from the system.
Initiating communicator, battery, and siren tests.
Determining system service conditions based on illuminated zone lights.
Steps and considerations for creating building evacuation plans.
Important safety precautions for installation and operation.
To Next Page
General
