12 Dansk 2202100
*2202100*
Trouble or fault Possible cause Action to be taken
4 LEDs on the battery flash. Protection against overheating. ▶ Allow the product to cool down
and clean the air vents.
Product does not develop full
power.
The control switch is not fully
pressed.
▶ Press the control switch as far
as it will go.
The half-power button is engaged. ▶ Press the "half-power" button.
Drill bit does not rotate. The function selector switch is not
engaged or is in the "Chiseling"
position or the "Chisel position-
ing" position .
▶ With the motor at a standstill,
set the function selector switch
to the "Hammer drilling"
position.
The insert tool cannot be re-
leased from the chuck.
The chuck is not pulled back fully. ▶ Pull the chuck back as far
as it will go and remove the
accessory tool.
The side handle is not fitted cor-
rectly.
▶ Disengage the side handle and
refit it correctly so that the
clamping band and side handle
engage in the recess.
Product does not start. The electronic restart interlock is
activated after an interruption in
the electric supply.
▶ Switch the product off and then
on again.
The service indicator lights. Service limit time reached. ▶ Have the product repaired by
Hilti Service.
The service indicator blinks. The product is faulty. ▶ Have the product repaired by
Hilti Service.
The ON/OFF indicator
flashes.
Product momentarily overloaded. ▶ Release the control switch and
then press it again.
Protection against overheating. ▶ Allow the product to cool down
and clean the air vents.
10 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
11 Manufacturer’s warranty
▶
Please contact your local Hilti representative if you have questions about the warranty conditions.
Original brugsanvisning
1 Oplysninger vedrørende dokumentationen
1.1 Vedrørende denne dokumentation
• Læs denne dokumentation igennem før ibrugtagning. Det er en forudsætning for sikkert arbejde og
korrekt håndtering.
• Følg sikkerheds- og advarselshenvisningerne i denne dokumentation og på produktet.
• Opbevar altid brugsanvisningen sammen med produktet, og overdrag det kun til andre personer sammen
med denne anvisning.
To Next Page
Loading...
