Hilti TE 60-A36 - Product Operation; Workplace Preparations and Battery Handling

10 English 2201899
*2201899*
Battery state of charge cannot be displayed while the control switch is
pressed and for up to 5 seconds after releasing the control switch.
If the battery display LEDs blink, please observe the instructions given
in the Troubleshooting section.
3.8 Items supplied
Combihammer, side handle, operating instructions.
Other system products approved for use with this product can be found at
your local Hilti Store or online at: www.hilti.group | USA: www.hilti.com
4 Technical data
TE 60-A36
Rated voltage
36 V
Weight
8.1 kg
(17.9 lb)
Single impact energy
8.1 J
Hammer drill bits, Ø
1/2 in …
2 3/16 in
Breach bits, Ø
1 9/16 in …
3 1/8 in
Percussion core bits, Ø
1 3/4 in … 4 in
PCM diamond core bits, Ø
1 1/2 in … 4 in
Drill bits for metal, Ø
1/4 in … 1/2 in
Drill bits for wood, Ø
13/32 in …
1 1/4 in
Chuck
TEY
5 Operation
5.1 Preparations at the workplace
Switch the product off or remove the battery before making adjustments
or changing accessories.
Observe the safety instructions and warnings in this documentation and on
the product.
5.1.1 Removing the battery 2
1. Press the release buttons on the battery.
2. Pull the battery out toward the rear.