Hiltron security PROTEC4 - Page 24

2.3.3 Telephone dialer
* ATTENTION!
If necessary connect the electronic key and the telephone dialers on the clips "Key"
it's necessary to use the exchanges of the relè in this way:
2.3.2 Reed contacts and volumetric detectors
ATTENTION!
TM400P, TM500P, TM900P, PROTEC4 e PROTEC9 don’t allow the connection of the
‘switch’ contacts for rolling shutters type C778 directly on the terminal boards becouse
this central unit hasn’t got an impulse counter. Use the SCHSW impulse counter board to
connect the ‘switch’ contact for rolling shutters type C778, or use the ‘switch’ contact for rolling
shutters C800 with integrated impulse counter for the direct connection to this central unit.
24 25
Long wires
Short wires
C401/P
In series to
the 24h line
ELECTRONIC
KEY
TELEPHONE
DIALERS
TELEPHONE
LINE
In series to
the 24h line
Remove
the arch
*
+
Sir
+
S.A.
-
12Vcc
int12V Chiave led key
V
Com
zone
24H Z1 Z3 Z4 Z5 Z6 Z7 Z8
NA
NCC
Alarm
+
-
R
+
-
Z2
+
Sir
+
S.A.
-
12Vcc
int12V
Key
led key
V
Com
zones
24H Z1 Z3 Z4 Z5 Z6 Z7 Z8
NO
NCC
Alarm
+
-
R
+
-
Z2
+
Sir
+
S.A.
-
12Vcc Int12V Key Led
G
Com
zones 24H Z1 Z3 Z4 Z5 Z6 Z7 Z8
NO
NCC
Alarm
+
-
Z2
Long wires
Short wires
Serie TM / Serie PROTEC burglary central unit - User’s manual Installation
TAMPER
+
OUT
Detector
C451
GND LINE PHONE TAMPER INT K1 K2
RELE 1
NC NO C
RELE 2
NC NO C
+
TELEPHONE DIALER
NO NC C
Out
C NC NO
Out
-
+
R
TM500P
TM900P
PROTEC9
TM500P - TM900P - PROTEC9
TM500P
TM900P
PROTEC9
security security