HIMA HIMax X-DI 64 51 - Connection Variants; Input Wiring; Figure 12: Wiring with Contact Maker or Two-Wire Proximity Switch; Figure 13: Wiring of a Digital Signal Source with Electrically Isolated Supply

4 Start-up X-DI 64 51
Page 38 of 50 HI 801 177 E 4.00
4.4 Connection Variants
This chapter describes the technically proper wiring of the module. The connection variants
specified here are permitted.
4.4.1 Input Wiring
The inputs are wired via connector boards. Special connector boards are available for
redundantly wiring the modules.
The supply is decoupled using diodes. This ensures that the supplies of two modules can
supply one proximity switch if the modules are redundant to one another
Connector boards X-CB 006 51 (with screw terminals) or X-CB 006 53 (with cable plug) can
be used to perform the wiring such as described in
Figure 12, Figure 13 and Figure 14.
Connector Board
S+
DI+
X-DI 64 51
1
2
Transmitter Supply Digital Input
Figure 12: Wiring with Contact Maker or Two-Wire Proximity Switch
Digital Input
Figure 13: Wiring of a Digital Signal Source with Electrically Isolated Supply