Hirschmann GigaLION-24TP - Show System

Command Line Interface
4-60
4
Related Commands
show startup-config (4-57)
show system
This command displays system information.
Default Setting
None
Command Mode
Normal Exec, Privileged Exec
Command Usage
• For a description of the items shown by this command, refer to “Displaying
System Information” on page 3-9.
• The POST results should all display “PASS.” If any POST test indicates
“FAIL,” contact your distributor for assistance.
Example
Console#show system
System description: Hirschmann GigaLION-24TP
System OID string: 1.3.6.1.4.1.248.13.7.5
System information
System Up time: 0 days, 1 hours, 23 minutes, and 44.61 seconds
System Name : [NONE]
System Location : [NONE]
System Contact : [NONE]
MAC address : 00-30-f1-47-58-3a
Web server : enable
Web server port : 80
Web secure server : enable
Web secure server port : 443
Telnet server : enable
Telnet port : 23
POST result
UART LOOP BACK Test...........PASS
DRAM Test.....................PASS
Timer Test....................PASS
PCI Device 1 Test.............PASS
Switch Int Loopback test......PASS
Crossbar Int Loopback Test ...PASS
Done All Pass.
Console#