Network Security
[ Network Security > 802.1X Port Authentication > Port Configuration ]
110
RM GUI GRS
Release
8.0
09/2019
Quiet period [s]
Specifies the time period in seconds in which the authenticator does not accept any more logins
from the end device after an unsuccessful log in attempt (
Quiet period [s]
).
Possible values:
0..65535
(default setting:
60
)
Transmit period [s]
Specifies the period in seconds after which the authenticator requests the end device to login again.
After this waiting period, the device sends an EAP request/identity data packet to the end device.
Possible values:
1..65535
(default setting:
30
)
Supplicant timeout period [s]
Specifies the period in seconds for which the authenticator waits for the login of the end device.
Possible values:
1..65535
(default setting:
30
)
Server timeout [s]
Specifies the period in seconds for which the authenticator waits for the response from the
authentication server (RADIUS or IAS).
Possible values:
1..65535
(default setting:
30
)
Requests (max.)
Specifies how many times the authenticator requests the end device to login until the time specified
in the
Supplicant timeout period [s]
column has elapsed. The device sends an EAP request/identity
data packet to the end device as often as specified here.
Possible values:
0..10
(default setting:
2
)
Assigned VLAN ID
Displays the ID of the VLAN that the authenticator assigned to the port. This value applies only on
ports in which the
Port control
column contains the value
auto
.
Possible values:
0..4042
(default setting:
0
)
You find the VLAN ID that the authenticator assigned to the ports in the
Network Security > 802.1X
Port Authentication > Port Clients
dialog.
Assignment reason
Displays the cause for the assignment of the VLAN ID. This value applies only on ports in which
the
Port control
column contains the value
auto
.
To Next Page
Loading...
