Switching
[ Switching > Rate Limiter ]
150
RM GUI GRS
Release
8.0
09/2019
Possible values:
percent
(default setting)
Specifies the threshold value as a percentage of the data rate of the port.
pps
Specifies the threshold value in data packets per second.
Broadcast mode
Activates/deactivates the rate limiter function for received broadcast data packets.
Possible values:
marked
unmarked
(default setting)
If the threshold value is exceeded, then the device discards the excess broadcast data packets on
this port.
Multicast mode
Activates/deactivates the rate limiter function for received multicast data packets.
Possible values:
marked
unmarked
(default setting)
If the threshold value is exceeded, then the device discards the excess multicast data packets on
this port.
Unknown unicast mode
Activates/deactivates the rate limiter function for received unicast data packets with an unknown
destination address.
Possible values:
marked
unmarked
(default setting)
If the threshold value is exceeded, then the device discards the excess unicast data packets on this
port.
Buttons
You find the description of the standard buttons in section “Buttons” on page 13.
To Next Page
Loading...
