Switching
[ Switching > IGMP Snooping > Querier ]
165
RM GUI GRS
Release
8.0
09/2019
Expiry interval [s]
Specifies the time in seconds after which an active querier switches from the passive state back to
the active state if it has not received any query packets for longer than specified here.
Possible values:
60..300
(default setting:
125
)
Table
In the table you specify the Snooping Querier settings for the VLANs that are set up.
VLAN ID
Displays the ID of the VLAN to which the table entry applies.
Active
Activates/deactivates the IGMP Snooping Querier function for this VLAN.
Possible values:
marked
The IGMP Snooping Querier function is active for this VLAN.
unmarked
(default setting)
The IGMP Snooping Querier function is inactive for this VLAN.
Current state
Displays whether the Snooping Querier is active for this VLAN.
Possible values:
marked
The Snooping Querier is active for this VLAN.
unmarked
The Snooping Querier is inactive for this VLAN.
Address
Specifies the IP address that the device adds as the source address in generated general query
data packets. You use the address of the multicast router.
Possible values:
Valid IPv4 address (default setting:
0.0.0.0
)
Protocol version
Displays the IGMP protocol version of the general query data packets.
To Next Page
Loading...
