Switching
[ Switching > L2-Redundancy > Link Aggregation ]
219
RM GUI GRS
Release
8.0
09/2019
Possible values:
active
The LAG interface aggregates the physical port.
inactive
The LAG interface does not aggregate the physical port.
LACP active
Activates/deactivates LACP on the physical port.
Possible values:
marked
(default setting)
LACP is active on the physical port.
unmarked
LACP is inactive on the physical port.
LACP port actor admin key
Specifies the physical port key. The device uses this key to identify the ports that can be aggregated
to the LAG interface.
Possible values:
0
The device ignores the key on this physical port when deciding to aggregate the port into the
LAG interface.
1..65535
If this value matches the value of the LAG interface specified in the
LACP admin key
column, then
the device only aggregates this physical port to the LAG interface.
LACP actor admin state
Specifies the actor state values that the LAG interface transmits in the LACPDUs. This lets you
control the LACPDU parameters.
The device lets you mix the values. In the drop-down list, select one or more values.
Possible values:
ACT
(
LACP_Activity
state)
When selected, the link transmits the LACPDUs cyclically, otherwise when requested.
STO
(
LACP_Timeout
state)
When selected, the link transmits the LACPDUs cyclically using the short timeout, otherwise
using the long timeout.
AGG
(
Aggregation
state)
When selected, the device interprets the link as a candidate for aggregation, otherwise as an
individual link.
For further information on the values, see the standard IEEE 802.1AX-2014.
LACP actor oper state
Displays the actor state values that the LAG interface transmits in the LACPDUs.
To Next Page
Loading...
