Hirschmann GREYHOUND GRS1020 - Page 230

Switching
[ Switching > L2-Redundancy > FuseNet > Sub Ring ]
229
RM GUI GRS
Release
8.0 09/2019
Possible values:
 manager
The subring port forwards data packets.
 redundantManager
The subring port is blocked while the subring is physically closed. If the subring is interrupted,
then the subring port transmits the data packets.
 singleManager
The subring is coupled to the base ring via one single device. The subring port of the instance
with the higher port number is blocked while the subring is physically closed.
 disabled
The subring is inactive.
Port status
Displays the connection status of the subring port.
Possible values:
 forwarding
The port is passing frames according to the forwarding behavior of IEEE 802.1D.
 disabled
The port is dropping every frame.
 blocked
The port is dropping every frame with the exception of the following cases:
– The port passes frames used by the selected ring protocol specified to pass blocked ports.
– The port passes frames from other protocols specified to pass blocked ports.
 not-connected
The port link is down.
VLAN
Specifies the VLAN to which this subring is assigned. If no VLAN exists under the VLAN ID entered,
then the device automatically creates it.
Possible values:
 Available configured VLANs (default setting: 0 )
If you do not want to use a separate VLAN for this subring, then you leave the entry as 0.
Partner MAC
Displays the MAC address of the subring manager at the other end of the subring.
MRP domain
Specifies the MRP domain of the subring manager. Assign the same MRP domain name to every
member of a subring. If you only use Hirschmann devices, then you use the default value for the
MRP domain; otherwise adjust this value if necessary. With multiple subrings, the function lets you
use the same MRP domain name for the subrings.
Possible values:
 Permitted MRP domain names (default setting:
255.255.255.255.255.255.255.255.255.255.255.255.255.255.255.255 )
Protocol
Specifies the protocol.