Diagnostics
[ Diagnostics > Ports > Port Monitor ]
282
RM GUI GRS
Release
8.0
09/2019
Buttons
You find the description of the standard buttons in section “Buttons” on page 13.
Reset
Enables the port highlighted in the table again and resets its counter to
0
. This affects the counters
in the following dialogs:
Diagnostics > Ports > Port Monitor
dialog
–
Link flap
tab
–
CRC/Fragments
tab
–
Overload detection
tab
Diagnostics > Ports > Auto-Disable
dialog
[Link speed/Duplex mode detection]
In this tab, you activate the allowed combinations of speed and duplex mode for each port.
The
Port Monitor
function monitors those ports for which the checkbox in the
Link speed/Duplex mode
detection on
column is marked on the
Global
tab.
The
Port Monitor
function monitors only enabled physical ports.
Table
Port
Displays the port number.
10 Mbit/s HDX
Activates/deactivates the port monitor to accept a half-duplex and 10 Mbit/s data rate combination
on the port.
Possible values:
marked
The port monitor takes into consideration the speed and duplex combination.
unmarked
If the port monitor detects the speed and duplex combination on the port, then the device
executes the action specified in the
Global
tab.
10 Mbit/s FDX
Activates/deactivates the port monitor to accept a full-duplex and 10 Mbit/s data rate combination
on the port.
To Next Page
Loading...
