Advanced
[ Advanced > DHCP L2 Relay > Configuration ]
311
RM GUI GRS
Release
8.0
09/2019
7.1.1 DHCP L2 Relay Configuration
[ Advanced > DHCP L2 Relay > Configuration ]
This dialog lets you activate the relay function on an interface and VLAN. When you activate this
function on a port, the device either relays the Option 82 information or drops the information on
untrusted ports. Furthermore, the device lets you specify the remote identifier.
The dialog contains the following tabs:
[Interface]
[VLAN ID]
Operation
Operation
Enables/disables the DHCP L2 Relay function of the device globally.
Possible values:
On
Enables the DHCP Layer 2 Relay function of the device.
Off
(default setting)
Disables the DHCP Layer 2 Relay function of the device.
[Interface]
Table
Port
Displays the port number.
Active
Activates/deactivates the
DHCP L2 Relay
function on the port.
The prerequisite is that you enable the function globally.
Possible values:
marked
The
DHCP L2 Relay
function is active.
unmarked
(default setting)
The
DHCP L2 Relay
function is inactive.
Trusted port
Activates/deactivates the secure
DHCP L2 Relay
mode for the corresponding port.
To Next Page
Loading...
