Hirschmann GREYHOUND GRS1020 - Page 362

User interfaces
1.2
Command Line Interface
22
UM Config GRS
Release
8.0 09/2019
Proceed as follows:
 Connect the device to a terminal using the serial interface. Alternatively connect the device to a
COM port of your PC using terminal emulation based on VT100 and press any key.
 Alternatively you set up the serial data connection to the device with the serial interface using
the PuTTY program. Press the <Enter> key.
Figure 7: Serial data connection with the serial interface using the PuTTY program
 Press any key on your terminal keyboard a number of times until the login screen indicates the
CLI mode.
 Enter the user name.
The default user name is admin .
 Press the <Enter> key.
 Enter the password.
The default password is private .
 Press the <Enter> key.
Note: This device is a security-relevant product. Change the password during the first startup
procedure.