User interfaces
1.2
Command Line Interface
31
UM Config GRS
Release
8.0
09/2019
radius server timeout
is the command name.
The parameter is required. The value range is
1..30
.
Example 3: radius server auth modify <1..8>
Command to set the parameters for RADIUS authentication server 1.
(GRS) (config)#radius server auth modify 1
[name] RADIUS authentication server name.
[port] RADIUS authentication server port.
(default: 1812).
[msgauth] Enable or disable the message authenticator
attribute for this server.
[primary] Configure the primary RADIUS server.
[status] Enable or disable a RADIUS authentication
server entry.
[secret] Configure the shared secret for the RADIUS
authentication server.
[encrypted] Configure the encrypted shared secret.
<cr> Press Enter to execute the command.
radius server auth modify
is the command name.
The parameter
<1..8>
(RADIUS server index) is required. The value range is
1..8
(integer).
The parameters
[name]
,
[port]
,
[msgauth]
,
[primary]
,
[status]
,
[secret]
and
[encrypted]
are
optional.
1.2.10 Input prompt
Command mode
With the input prompt, the Command Line Interface displays which of the three modes you are in:
(GRS) >
User Exec mode
(GRS) #
Privileged Exec mode
(GRS) (config)#
Global Config mode
(GRS) (Vlan)#
VLAN Database mode
(GRS) ((Interface)all)#
Interface Range mode / All ports of the device
(GRS) ((Interface)2/1)#
Interface Range mode / A single port on one interface
(GRS) ((Interface)1/2-1/4)#
Interface Range mode / A range of ports on one interface
(GRS) ((Interface)1/2,1/4,1/5)#
Interface Range mode / A list of single ports
(GRS) ((Interface)1/1-1/2,1/4-1/6)#
Interface Range mode / A list of port ranges and single ports
To Next Page
Loading...
