Managing configuration profiles
4.3
Loading settings
74
UM Config GRS
Release
8.0
09/2019
4.3 Loading settings
If you save multiple configuration profiles in the memory, then you have the option to load a different
configuration profile.
4.3.1 Activating a configuration profile
The non-volatile memory of the device can contain multiple configuration profiles. If you activate a
configuration profile stored in the non-volatile memory (
NVM
), then you immediately change the
settings in the device. The device does not require a reboot.
Perform the following steps:
Open the
Basic Settings > Load/Save
dialog.
In the table, select the entry of the required configuration profile.
Click the button and then the
Activate
item.
The device copies the settings to the memory (
RAM
) and disconnects from the Graphical User
Interface. The device immediately uses the settings of the configuration profile.
Reload the Graphical User Interface.
Log in again.
In the
Selected
column, the checkbox of the configuration profile that was activated before is
marked
.
show config profiles nvm
Displays the configuration profiles contained in the
non-volatile memory (
nvm
).
enable
Change to the Privileged EXEC mode.
copy config nvm profile config3
running-config
Activate the settings of the configuration profile
config3
in the non-volatile memory (
nvm
).
The device copies the settings into the volatile
memory and disconnects the connection to the
Command Line Interface. The device immediately
uses the settings of the configuration profile
config3
.
To Next Page
Loading...
