Basic Settings
[ Basic Settings > Port ]
47
RM GUI GRS
Release
8.0
09/2019
Possible values:
10 Mbit/s HDX
Half duplex connection
10 Mbit/s FDX
Full duplex connection
100 Mbit/s HDX
Half duplex connection
100 Mbit/s FDX
Full duplex connection
1000 Mbit/s FDX
Full duplex connection
Note: The operating modes of the port actually available depend on the device configuration and
the media module used.
Link/Current settings
Displays the operating mode which the port currently uses.
Possible values:
–
No cable connected, no link.
10 Mbit/s HDX
Half duplex connection
10 Mbit/s FDX
Full duplex connection
100 Mbit/s HDX
Half duplex connection
100 Mbit/s FDX
Full duplex connection
1000 Mbit/s FDX
Full duplex connection
Note: The operating modes of the port actually available depend on the device configuration and
the media module used.
Manual cable crossing (Auto. conf. off)
Specifies the devices connected to a TP port.
The prerequisite is that the
Automatic configuration
function is disabled.
Possible values:
mdi
The device interchanges the send- and receive-line pairs on the port.
mdix
(default setting on TP ports)
The device helps prevent the interchange of the send- and receive-line pairs on the port.
auto-mdix
The device detects the send and receive line pairs of the connected device and automatically
adapts to them.
Example: When you connect an end device with a crossed cable, the device automatically
resets the port from
mdix
to
mdi
.
unsupported
(default setting on optical ports or TP-SFP ports)
The port does not support this function.
To Next Page
Loading...
