Basic Settings
[ Basic Settings > Port ]
50
RM GUI GRS
Release
8.0
09/2019
To reset the counter for the port statistics in the table to
0
, proceed as follows:
In the
Basic Settings > Port
dialog, click the button and then the
Clear port statistics
item.
or
In the
Basic Settings > Restart
dialog, click the
Clear port statistics
button.
Buttons
You find the description of the standard buttons in section “Buttons” on page 13.
Clear port statistics
Resets the counter for the port statistics to
0
.
[Utilization]
This tab displays the utilization (network load) for the individual ports.
Table
Port
Displays the port number.
Utilization [%]
Displays the current utilization in percent in relation to the time interval specified in the
Control
interval [s]
column.
The utilization is the relationship of the received data quantity to the maximum possible data
quantity at the currently configured data rate.
Lower threshold [%]
Specifies a lower threshold for the utilization. If the utilization of the port falls below this value, then
the
Alarm
column displays an alarm.
Possible values:
0.00..100.00
(default setting:
0.00
)
The value
0
deactivates the lower threshold.
Upper threshold [%]
Specifies an upper threshold for the utilization. If the utilization of the port exceeds this value, then
the
Alarm
column displays an alarm.
Possible values:
0.00..100.00
(default setting:
0.00
)
The value
0
deactivates the upper threshold.
To Next Page
Loading...
