Redundancy
12.7
FuseNet
180
UM Config GRS
Release
8.0
09/2019
12.7 FuseNet
The
FuseNet
protocols let you couple rings that are operating with one of the following redundancy
protocols:
MRP
RSTP
Note: When you use the
Ring/Network Coupling
protocol to couple a network to the main ring, verify
that the networks contain only Hirschmann devices.
Use the following table to select the
FuseNet
coupling protocol to be used in your network:
Explanation:
Main Ring Connected Network
MRP RSTP HIPER ring
MRP
Sub Ring
1)
RSTP – – –
– no suitable coupling protocol
1)
with
MRP
configured on different VLANs
To Next Page
Loading...
