Industry Protocols
15.1
IEC 61850/MMS
237
UM Config GRS
Release
8.0
09/2019
Monitoring the device
The IEC61850/MMS server integrated into the device lets you monitor multiple statuses of the
device by means of the Report Control Block (RCB). Up to 5 MMS clients can register for a Report
Control Block at the same time.
The device lets you monitor the following statuses:
Table 39: Statuses of the device that can be monitored with IEC 61850/MMS
Class RCB object Description
LN LPHD TmpAlm
When the temperature measured in the device exceeds or falls
below the set temperature thresholds, the status changes.
PhyHealth
When the status of the
LPHD.TmpAlm
RCB object changes, the
status changes.
LN LPHD TmpAlm
When the temperature measured in the device exceeds or falls
below the set temperature thresholds, the status changes.
PwrSupAlm
When 1 of the redundant power supplies fails or starts operating
again, the status changes.
PhyHealth
When the status of the
LPHD.PwrSupAlm
or
LPHD.TmpAlm
RCB object
changes, the status changes.
LN LBRI RstpRoot
When the device takes over or relinquishes the role of the root
bridge, the status changes.
RstpTopoCnt
When the topology changes due to a change of the root bridge,
the status changes.
LN LCCH ChLiv
When the link status of the physical port changes, the status
changes.
LN LPCP PhyHealth
When the link status of the physical port changes, the status
changes.
To Next Page
Loading...
