38
Installation GRS1020/1120/1030/1130
Release
03
01/2017
For every supply voltage to be connected, perform the following steps:
Remove the power connector from the device.
Connect the wires according to the pin assignment on the device with the
clamps.
Fasten the wires connected by tightening the terminal screws.
2.4.3 Signal contact
Connect the signal contact wires with the connectors of the terminal block.
Fasten the wires connected by tightening the terminal screws.
WARNING
ELECTRIC SHOCK
Install this device solely in a switch cabinet or in an operating site with
restricted access, to which maintenance staff have exclusive access.
Failure to follow these instructions can result in death, serious injury,
or equipment damage.
To Next Page
Loading...
