MACH 4002
Release
1.0
10/05
19
V Please observe the “ESD guidelines” on page 8 “ and the “Safety instruc-
tions” on page 5ff.
V Close the whole of the front surface beside the media modules with pa-
nels. This guarantees optimum shielding and convection. The slots for the
media modules function identically. They can be selected in any order.
V Remove the covering panel to insert the media module.
V Note the positions of the blue insertion catches (see Fig., step 1).
V Insert the media module almost as far as it will go into the desired slot
(see
Fig., step 2).
V Make sure that there is a good connection between the multiple plugs of
the media modules and the female multipoint of the system bus.
V Insert the media module as far as it will go into the desired slot by closing
the blue insertion catches (see Fig., step 3).
V Screw the two knurled screws in the front panel of the media module flush
with the frame of the chassis.
2.1.3 Assembling the SFP modules (if required)
V To fasten a SFP module, first remove the protective cap of the SFP mo-
dule.
V Insert the SFP module with the closed lock into the socket until you hear
it snap in.
Note: Only use SFP modules from Hirschmann.
Step 1
Step 3
Step 2
To Next Page
Loading...
