MACH 4002
Release
1.0
10/05
25
Fig. 7: Pin assignment of a 1000 MBit/s twisted pair interface
U 100 Mbit/s F/O connection
100 MBit/s F/O ports (SFP slots) enable the connection of terminal
devices or independent network segments in compliance with the IEEE
802.3 100BASE-FX standard. These ports support:
D full duplex mode
State on delivery: full duplex.
Note: Make sure, that you conncet LH ports only to LH ports, SM ports
only to SM ports and MM ports only to MM ports.
U 1 Gbit/s F/O connection
1 Gbit/s F/O ports (SFP slots) enable the connection of terminal devices
or independent network segments in compliance with the IEEE 802.3-
2000 (ISO/IEC 8802-3:2000) 1000BASE-SX or 1000BASE-LX standard.
These ports support:
D autonegotiation,
D full duplex mode
State on delivery: autonegotiation.
Note: Make sure, that you conncet LH ports only to LH ports, SX ports
only to SX ports and LX ports only to LX ports.
V Connect the data lines according to your requirements.
2.1.12 Replacing the M4-AIR fan plug-in unit
(if required)
Pin 8
Pin 7
Pin 6
Pin 5
Pin 4
Pin 3
Pin 2
Pin 1
BI_DC-
BI_DC+
BI_DA-
BI_DD-
BI_DD+
BI_DA+
BI_DB-
BI_DB+
To Next Page
Loading...
