MACH 4002
Release
1.0
10/05
3
Content
Safety instructions 5
About this manual 10
Legend 10
1 Description of the device 11
1.1 Basic device MACH 4002 48+4G 12
1.2 Voltage supply 14
1.2.1 Power supply on back of device 14
1.2.2 M4-POWER power unit chassis 14
1.3 Fan plug-in unit M4-AIR 15
1.4 Integated Basic Board 16
1.4.1 4 Gigabit ETHERNET ports (Combo) 16
1.4.2 16 Fast ETHERNET ports 16
1.5 Media modules 17
1.5.1 Fast ETHERNET ports 17
2 Assembly and startup procedure 18
2.1 Assembling the device 18
2.1.1 Unpacking and checking 18
2.1.2 Assembling the media modules 18
2.1.3 Assembling the SFP modules (if required) 19
2.1.4 Assembling the power supply unit on the back of the device 20
2.1.5 Assembling the slide-in power units to the
power unit chassis (if required) 20
2.1.6 Setup or installation of the device in a 19" rack 21
2.1.7 Grounding the device 21
2.1.8 Assembling the power unit chassis (if required),
Connecting to the MACH 4002 21
2.1.9 Connecting the terminal block for signal contact 22
2.1.10Connecting the supply voltage, startup procedure 23
2.1.11Connecting the data lines 24
2.1.12Replacing the M4-AIR fan plug-in unit
(if required) 25
2.2 Displays 26
2.3 Carrying out basic settings 31
To Next Page
Loading...
