MACH 4002
Release
1.0
10/05
7
D trained or directed or authorized to switch on and off, to ground and to
label power circuits and devices or systems in accordance with current
safety engineering standards;
D trained or directed in the care and use of appropriate safety equipment
in accordance with the current standards of safety engineering;
D trained in providing first aid.
U General Safety Instructions
This device is electrically operated. Adhere strictly to the safety require-
ments relating to voltages applied to the device as described in the ope-
rating instructions!
Failure to observe the information given in the warnings could result in
serious injury and/or major damage.
V Only personnel that have received appropriate training should operate
this device or work in its immediate vicinity. The personnel must be ful
-
ly familiar with all of the warnings and maintenance measures in these
operating instructions.
V Correct transport, storage, and assembly as well as careful operation
and maintenance are essential in ensuring safe and reliable operation
of this device.
V Only use undamaged parts!
V These products are only to be used in the manner indicated in this ver-
sion of the manual.
V Any work that may have to be performed on the electrical installation
should be performed by fully qualified technicians only.
Warning!
LED- or LASER components according to IEC 60825-1 (2001):
CLASS 1 LASER PRODUCT.
LIGHT EMITTING DIODE - CLASS 1 LED PRODUCT.
U National and international safety regulations
V Make sure that the electrical installation meets local or nationally ap-
plicable safety regulations.
To Next Page
Loading...
