14
Installation OZD Profi 12M ...
Release
01
07/2017
Measuring output
One measuring output is available for each optical port. The measuring
output is connected to the 8-pin screw type terminal block.
Configuration
You can easily set the configuration to meet your specific requirements by
means of DIP switches, which can easily be operated from outside.
The following settings are possible:
Setting the compatibility to OZD Profi …a version
See “Setting compatibility” on page 40.
Setting the operating mode and transmitting power
See “Setting the operating mode and transmitting power” on page 43.
Reducing the optical transmitting power
See “Reducing the optical transmitting power” on page 45.
To Next Page
Loading...