Hirschmann OZD Profi 12M G11 - Setting the Operating Mode of the Optical Ports (CH3, CH4)

44
Installation OZD Profi 12M ...
Release 01 07/2017
 Operating mode: electrical ports (CH1,CH2) without
segment monitoring
4.4.2 Setting the operating mode of the optical ports (CH3,
CH4)
The operating mode can be set individually for each optical port.
Combinations of the operating modes “Line with optical fiber link monitoring”
and “Line without optical fiber link monitoring” are also possible. Note that the
operating mode of the two optical ports which are connected by the fiber line
must always have the same settings. The operating mode “Redundant
optical ring” must always be set at both of the optical ports.
 Operating mode: Line with optical fiber link monitoring and
segmentation
CH1 is activated in this operating mode if S0 is in Position 1. Please note that
this operating mode should only be set in the star segment of the star topology.
Applies to device variants with 2 electrical ports:
CH2 is activated in this operating mode if S1 is in Position 1. Please note that
this operating mode should only be set in the star segment of the star topology.
CH3 is activated in this operating mode if S2 and S3 are in Position 0.
CH4 is activated in this operating mode if S4 and S5 are in Position 0.
CH 3
CH 4
CH 3
CH 4
CH 1
CH 2
10
S
1
S
0
S
6
S
5
S
3
S
2
S
4
S
7
S 8
CH 3
CH 4
CH 3
CH 4
CH 1
CH 2
10
S
1
S 0
S 6
S 5
S 3
S 2
S 4
S 7
S 8
CH 3
CH 4
CH 3
CH 4
CH 1
CH 2
10
S
1
S
0
S
6
S
5
S
3
S
2
S
4
S
7
S 8