4
The glasses will automatically turn off in the following condition: to save power
1. When the glasses are turned on, the glasses will enter standby mode for 1.5 minutes
if no 3D sync signal received. the glasses will turn in to working mode once the glasses
receive the 3D sync signal during standby mode, otherwise, the glasses will automatically
turn off with the green LED indicator blinking three times.
2. If the glasses become disconnected with the emitter because of incorrect distance and
or angle, they will automatically work for a period of 5 seconds. The glasses will resume
working once a 3D sync signal is received, otherwise, the glasses will enter into standby
mode(for 1.5 minutes).
3. If you change the channel or input while watching 3D content, the glasses will automatically
work for a period of 5 seconds. the glasses will resume working once 3D sync signal
is received, otherwise, the glasses will enter into standby mode(for 1.5 minutes).
Q1: What can I do if there is no 3D effect after I have put on and turned on the glasses?
Try this:
1. Make sure you are watching in 3D sync signal covered area .
2. Check the battery volume of your glasses, please charge if low in power
3. Please check if the TV setup is in 3D mode or not.
Q2: Why do the lenses blink when watching 3D films?
1. Please charge the glasses immediately if the battery is seriously low.
2. Interference such as magnetic fluorescent lamps (50 or 60Hz) may cause flickers,
please turn off interference source i . f this occurs
Tips
Troubleshooting
Try this:
To Next Page
Loading...