Hisense HCHS-N06X - Installation; Changing The Location Of The Electrical Box

Service Cover for
Electronic Expansion Valve
Electrical Box
Service Cover for
Electrical Box
(1)
(1)
(2)
(3)
(3)
(4)
(5)
(5)
(6)
A
(2) (6)
(6)
(7)
(7)
Edge Saddle
Wire Clip
Edge Saddle
Electrical Box
Edge Saddle
Wire Clip *
Edge Saddle
Electrical Box
MVD1
MVS1
MVD1
MVS1
(Before Change)
(After Change)
4.4 Installation
4.4.1 ChangingtheLocationoftheElectricalBox
Dependingontheinstallationspace,changingthelocationoftheelectricalboxisavailable.
Whenchangingthelocationoftheelectricalbox,followtheproceduresbelow:
(1) Removetheservicecoverfortheelectricalbox.
(2) Removetheservicecoverfortheelectronicexpansionvalve.
(3) Removetheelectricalbox.
(4) Removethewiringfromthewireclipandedgesaddle,andmovetheelectricalbox.
Aftermovingtheelectricalbox,putthewiringintotheedgesaddleandboundwiththewireclip.
(Referto“EnlargedViewofA”below.)
(5) Mounttheelectricalbox.
(6) Rotatetheservicecoverfortheelectronicexpansionvalve180degreesandmountit.
(7) Mounttheservicecoverfortheelectricalbox.
* Makesurethatthewiringisboundwiththewireclips
inordertopreventtheelectricalboxfromentering
water.
EnlargedViewofA
7