Hisense HCHS-N06X - Marking Of The Positions Of The Suspension Bolts And Wiring Connections; Mounting And Hanging The Switch Box

8
30 to 50mm
(1-3/16 to
1-15/16 inch)
Suspension Bolt (M10 or W3/8)
(Field-Supplied)
Nut (Field-Supplied)
Double-Nut (Field-Supplied)
Washer (Field-Supplied)
Suspension Bracket
(Equipped with Switch
Box)
Washer (Field-Supplied)
Switch Box
Suspension Bolt
Suspension Bracket
Upper Side
Figure4.4Suspension
Bottom Side
Figure4.5HangingMethod
4.4.3 MountingandHangingtheSwitch Box
(1) Putnutsoneachofthetwosuspensionbolts
beforehangingtheSwitch Box,as
showninFigure4.4.
T
Mountingwashersarerequiredinorder
toafxthesuspensionbrackettothe
suspensionbolt.
Field-SuppliedParts
* SuspensionBolt: 2-M10orW3/8
* Nut:
* Washer:
6-M10orW3/8
4-M10orW3/8
(2) HangingtheSwitch Box
(a)HangtheSwitch Boxbyputtinghandsonthe
bottomofthecabinet.
(b) Insertthesuspensionboltintothegroove
partofthesuspensionbracketasshown
inFigure4.5.Ensurethatthewashers
arecorrectlyafxedtothesuspension
bracket.
(c) Afterthehangingwork,thepipingand
wiringconnectionworkisrequiredinside
theceilinginthegapbetweentheroofand
ceilingsoitisnotvisible.Therefore,
determinethedrawingdirectionofthepipe
afterselectingtheinstallationlocationofthe
Switch Box.Beforedoingthehanging
work,carryoutthepipingandwiringwork
uptotheconnectingpositions.
(d) KeeptheSwitch Boxleveltotheceiling
surface.IftheSwitch Boxisnotlevel,a
malfunctionmayoccur.
(e) Tightenthenutsofthesuspension
boltwiththesuspensionbracketafter
adjustmentiscompleted.
Adhesivemustbeappliedtothenutsin
ordertopreventthemfromloosening.
4.4.2 MarkingofthePositionsoftheSuspension
BoltsandWiringConnections
(1) Markthepositionsofthesuspensionbolts,
refrigerantpipingconnectionsandwiring
connection.
(2) Installationdimensionsareshownin
Figure2.1.