63
Problem: Cause or remedy:
PF will appear on the
display unit (control unit
3).
• An extended power failure.
E0 will appear on the
display unit (control unit
3).
• Sensor keys are not responding. Call a service
centre for repair.
• Until the appliance is repaired by a service
technician, the appliance will operate in safe mode.
The appliance will automatically preserve the most
suitable temperature for each compartment.
E1 or E2 will appear on
the display unit (control
unit 3).
• Temperature sensor error or fault. Call a service
centre for repair. Until the appliance is repaired by a
service technician, the appliance will operate in safe
mode. The appliance will automatically preserve the
most suitable temperature for each compartment.
E9 will appear on the
display unit (control unit
3).
• Door was open for too long. Close the door.
• If the lighting in the compartment does not function
either, then there is a door sensor fault. Call a service
centre to arrange a repair. The appliance will operate
in safe mode until it is repaired. The appliance will
automatically preserve the most suitable temperature
for each compartment.
If the above tips do not resolve your problem, call the nearest authorized service
centre and state the type, model, and serial number indicated on the appliance
rating plate or label located in the appliance interior.
818898
To Next Page
Loading...
