5. Remove the upper door and place it
on a smooth surface with its panel
upwards. Lever part①and part④ then
loose screws② , as shown in the
picture. Change handle③ to the right
side, then install screws②, part① and
part④ in turn. screws⑦ ,
detach part⑥ and part⑤ then install
part⑤and another part⑥(in the plastic
bag)to the left side with screws⑦ .Put
part⑥ just detached back to plastic
bag.
,
Loosen
in
② Special self-tapping screws
③ Handle
① Handle covers
④ Screw hole covers
⑤ Door holder
⑥ Stop block
⑦ Self-tapping screws
6. screws used to fix the
middle hinge and remove middle
hinge. Then remove the lower door.
Loosen
1 2
1
2
3
② Special self-tapping screws
③ Handle
① Handle covers
④ Screw hole covers
⑤ Door holder
⑥ Stop block
⑦ Self-tapping screws
1
2
8. Change screw hole covers on
middle cover plate from left to right (as
shown in figure below).
9. remove
part③ and then loose screws④ .
Remove part ② and part①.
Tilt refrigerator back and
10. Screw out lower hinge
the near hole site, and then
and mount washer.
pin and
move it to
tighten into place
② Front foot fixed board
④ Self-tapping screws
③ Adjustable bottom feet part
① Lower hinge part（right）
Note: washer may
stick to lower door.
washer
11. step 9,change part①to
left and part②to right and then fix them
with screws④. Finally install part③.
Referring to
9
7.
surface with its panel upwards.
Change the handle to the right side
according to step 5. Loosen
screws⑦，detach part⑥and part
⑤.Turn part⑤by 180 and then
install part⑤and part⑥to
corresponding position on left side
together with screws⑦.
Place the lower door on a smooth
Hisense Refrigerator
To Next Page