Hisense U7 Series User Manual

9
Insert the batteries
1. Take off the back cover to open the battery compartment of the remote control.
2. Insert two AA or AAA (1.5Vcc) size batteries. Make sure to match the (+) and (-)
ends of the batteries with the (+) and (-) ends indicated in the battery compartment.
3. Restore the battery compartment cover.
Important information about the remote and batteries
• Discardbatteriesinadesignateddisposalarea.Donotthrowthemintoafire.
• Removeoldbatteriesimmediatelytopreventthemfromleakingintothebattery
compartment.
• Ifyoudonotintendtousetheremotecontrolforalongtime,thenremovethe
batteries.
• Batterychemicalscancausearash.Ifthebatteriesleak,cleanthebattery
compartment with a cloth. If chemicals touch your skin then wash it immediately.
• Donotmixoldandnewbatteries.
• Donotmixalkaline,standard(carbon-zinc)orrechargeable(NiCd,NiMH,etc.)
batteries.
• Donotcontinueusingtheremoteifitgetswarmorhot.
• CallourSupportCenterimmediatelyonthesupportwebsite.
Remote control range information
•
The remote control can work at a distance of up to 26 feet (792.5 cm) in front of the TV set.
• It can work at a 30 degree horizontal or vertical angle.
Pairing the remote control
1. PairtheremotetotheTVafteryoupoweritonforthersttime,therewillbe
instructions on how to pair the remote.
2. If your remote fails to pair with TV, keep the remote within 10 feet (304.8 cm) from
the TV, press and hold the [
] button and [ ] button at the same time at least 3
seconds to start pairing.
3. Iftheremotepairssuccessfully,aconrmationwilldisplayonthescreen.Ifitdoes
not pair successfully, an unsuccessful message will display. Repeat step 2, or you
can press [ ] button to select
Settings
>
Remotes & Accessories
>
Bluetooth
to On.
NOTE:
• If an unknown error occurs with the remote, it could have been caused by
interference. Try to remove what's causing the interference and pair the remote
again.
• If an unknown error occurs with the remote control while the battery power is
normal, you can take out the batteries and press any key for 1~2 seconds, and
insert them back. The remote control can work normally.
• The remote cannot be paired to the TV while the TV is in the standby mode.

Hisense U7 Series Specifications

General

Display Type	LED
HDR	Dolby Vision, HDR10, HDR10+, HLG
Refresh Rate	120Hz
Backlight Type	Full Array Local Dimming
Smart Platform	Google TV
Voice Assistant	Google Assistant, Amazon Alexa
HDMI Ports	4
USB Ports	2
Bluetooth	Yes
Dimensions (Without Stand)	Varies by screen size
Weight (Without Stand)	Varies by screen size
Resolution	4K (3840 x 2160)
Processor	Quad-Core
Smart Features	Screen Mirroring, App Store, Voice Control
Sound	DTS Virtual:X