CHECKING AND SERVICE THE STEERING
COLUMN PARTS
1. Check:
• steering column tube ①
• bearing ②
• central axis of the steering shaft ③
• spline ④
• loosening ⑤
The central axis of the steering shaft whether
flexible and moves. If does, dismantle and
check
the axis, bearing and retaining ring whether
ware or damaged, according to the inspection
situation to instead the parts.
2. Check:
The two ends of the spline on the central axis
whether is wear out, if so, instead the central
axis.
3. Check:
The spline in the two ends of the central axis
whether have wear, if dose, instead the
central axis.
4. Check:
The steering shaft tube and welding line of the
branch whether have crack and corrosion, if it
does, instead the steering shaft tube.
DIASSEMBLING THE STEERING DRIVE
AXLE
1. Loose the clamp one piece flange bolt in the
cross gimbal, internal spline on the top of the
To Next Page
Loading...