Battery Charger
Each EV is equipped with a special battery charger.
A special matching test upon battery and its charger has been done. Other types of
charger will fail to charge. If other charger is used to charge, it may undercharge,
overcharge and affect the usage of the battery.
WARNING:
⚫ The charging area must be ventilated. Hydrogen level in the air must never
exceed 2%. The total volume of air in the charging area must be changed
five times per hour, Exhaust fans should be located if necessary.
⚫ To connect the charger plug to the vehicle receptacle, grasp the plug handle
and push the plug straight into the receptacle. And then put the charger
plug to AC power receptacle. Fully charged, remove the charger in the
opposite order. Or it could damage the plug and receptacle and could cause
battery to explode.
⚫ Do not charge the vehicle batteries with the vehicle covered or enclosed.
Any enclosure or cover should be removed or unzipped and pulled back
when batteries are being charged. An accumulation of hydrogen gas could
result in an explosion.
⚫ Only trained technicians are allowed to repair or service the charger. Any
problems encountered in the maintenance of the charger, please contact
your local distributor/dealer.
⚫ Each charger should have its own dedicated 25 ampere separately
protected (circuit breaker or fuse) single phase branch circuit, in
accordance with all applicable electrical codes for the location.
⚫ Connect the charger with AC power cord, and ensure voltage and frequency
of 90~265V/45~65HZ.
⚫ An extension cord or electrical outlet must accept a three-prong plug.
Improper receptacle can cause fire or personal injury.
⚫ Do not operate the charger if it has received a sharp blow, was dropped, or
otherwise damaged in any way.
⚫ Have worn, cut, or damaged power cords or wires replaced immediately.
⚫ Do not use the charger near fuels, grain dust, solvents, thinners, or other
flammables. objects. Chargers can ignite flammable materials and vapors.
⚫ Do not expose to rain or any liquid. Keep the charger dry.
⚫ Never push objects of any kind into the charger through cabinet slots. They
may touch dangerous voltage points or cause an electrical short circuit that
could result in fire or electrical shock.
⚫ Do not allow clothing, blankets, or other material to cover the charger.
⚫ Do not block or cover the charger ventilation slots. The slots provide
ventilation and protect the charger from overheating.
⚫ Install arrester for the input AC cable. Arrester will help to protect the
To Next Page
Loading...