Hitachi airCore 700 - Safety Summary

1
INSTALLATION & MAINTENANCE MANUAL
1. Safety Summary
•
Please carefully read this section before installing the Zoning Kit.
•
Contents with “ ” shows the certain cases where improper operation WILL result in severe
personal injury or even death. For your safety, please follow the instruction.
•
Ensure that the entire system is correctly wired and installed before turning on power. Once the
appropriate checks have been made, turn the power on to the zoning kit and the air conditioning system.
Signal Words
Indicates a hazardous situation that, if not avoided, could result in death or
serious injury.
Indicates a hazardous situation that, if not avoided, could result in minor or
moderate injury.
Indicates information considered important, but not hazard-related (for
example, messages relating to property damage).
General Precautions
To reduce the risk of serious injury or death, read these instructions thoroughly
and follow all warnings or cautions included in all manuals that accompanied
the product and are attached to the unit. Refer back to these safety instructions
as needed.
•
This air conditioning system, including this Zoning Kit, should be installed by personnel qualied
according to local, state and national building and safety codes and regulations. Incorrect installation
could cause leaks, electric shock, re or an explosion. In areas where Seismic Performance
requirements are specied, the appropriate measures should be taken during installation to guard
against possible damage or injury that might occur in an earthquake. If the unit is not installed
appropriately, injuries may occur because of a falling unit.
•
Use appropriate Personal Protective Equipment (PPE), such as gloves, protective goggles and
electrical protection equipment and tools suited for electrical installation purposes.
•
When transporting, be careful when picking up, moving and mounting these units. Although the
controller (including Wired Remote Controller and Thermostat) may be packed using plastic straps,
do not use them for transporting from one location to another. Do not stand on or put any material on
the controller.
•
When connecting the controller cabling to the units, do not touch or adjust any safety devices inside
the products. All safety features, disengagement, and interlocks must be in place and functioning
correctly before the equipment is put into operation. If these devices are improperly adjusted or
tampered with in any way, a serious accident can occur. Never bypass or short-out any safety device or
switch.
•
Use only Johnson Controls-Hitachi Air Conditioning genuine replacement parts.
•
Johnson Controls-Hitachi Air Conditioning will not assume any liability for injuries or damage caused
by not following steps outlined or described in this manual. Unauthorized modications to Johnson
Controls-Hitachi Air Conditioning products are prohibited as they:
○
May create hazards which could result in death, serious injury or equipment damage;
○
Will void product warranties;
○
May invalidate product regulatory certications.