Hitachi CB 520H A1 - Page 305

No. Item Description
Default
Value
Supported
LPAR
manager
Version
(14) LP-SVP
Communicati
on
Displays the protocol that is used for
communication between the LPAR
manager and the management module.
IPv4: IPv4 is used.
IPv6(Static): IPv6 is used.
The protocol set on the management
module is applied to this item.
IPv4 02-25~
(15) IPv6 Static
Address
Displays whether use of IPv6 static
addressing is enabled or disabled.
Enable: The IPv6 static address is used.
Disable: The IPv6 static address is not
used.
The IPv6 static address set on the
management module is applied to this
item.
Disable 02-25~
(16) LP IP Address
(IPv6)
Displays the LP IPv6 address.
The LP IPv6 address set on the
management module is applied to this
item.
- 02-25~
(17) Prefix Length Displays the prefix length of the LP IPv6
address. The prefix length set on the
management module is applied to this
item.
- 02-25~
(18) Default
Gateway
(IPv6)
Displays default gateway for the LP IPv6
address.
The default gateway set on the
management module is applied to this
item.
- 02-25~
(19) SVP IP
Address
(IPv6)
Displays the SVP IPv6 address.
The SVP IPv6 address set on the
management module is applied to this
item.
- 02-25~
(20) LP CLI1~8
IP Address
(IPv6)
Sets LP CLI IP Address.
Sets the IP address of a server from
which HvmSh commands are issued.
:: 02-25~
(21) IPv6
Stateless
Address
Specifies whether use of the IPv6
stateless addressing is enabled or
disabled.
Enable: The IPv6 stateless address is
used.
Disable: The IPv6 stateless address is
not used.
Disable 02-25~
Operation by LPAR manager Screen
7-67
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide