Message Content LP Loader deleted the initial parameter.
Explanation LPAR manager detected the initial parameter file (InitParam.dat)
and deleted it.
What to do The initial parameter file is deleted due to the following reasons,
which are divided by LP System Logs detailed messages.
- Restore is performed with Web console, CLI console.
- Initialization is performed with Web console, CLI console.
- Cloning is performed with BSM.
- N+M cold standby is performed.
- Discrepancy between blade serial numbers.
Message Content LP Loader detected load error and recovered.
Explanation Configuration information failed to be read; however, this error
was corrected.
What to do If this LP System Logs is obtained each time LPAR manager
starts, contact the reseller from which you purchased this
equipment or consult maintenance personnel.
Message Content LP started retrying the setting of TxRate configuration.
Explanation LPAR manager starts to retry the setting of TxRate configuration,
due to the setting failure.
What to do Wait for a while.
Message Content LP System Shutdown Failed.
Explanation Failed to shutdown the LPAR manager system.
What to do Contact the reseller from which you purchased this equipment or
consult maintenance personnel.
Message Content LP-LFW detected failure of getting boot device.
Explanation LPAR manager logical firmware detected a failure to get boot
device.
What to do Contact your reseller or maintenance personnel.
Message Content LP-LFW detected failure of setting boot order.
Explanation LPAR manager logical firmware detected a failure to set a boot
order.
What to do Check and fix the boot order setting file. If it does not work,
contact your reseller or maintenance personnel.
9-42
Messages
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
To Next Page
Loading...
Need help?
General