Note: When the following error messages are indicated after setting
MultiChannel Configuration, return to MultiChannel Configuration
dialog box by pressing any key, and then set again the correct
parameters.
1. The following message is indicated when Bandwidth is set but LPVID
is not set, the cursor is moved onto Save, and then Enter is pressed.
2. The following message is indicated when same LPVID are set in
multiple columns, the cursor is moved onto Save, and then Enter is
pressed.
3. The following message is indicated when the sum of Bandwidth is not
100%, the cursor is moved onto Save, and then Enter is pressed.
13. Select the port#1, and then press Enter.
14. Repeat the procedures from step 10 to step 12.
15. Press Esc key until the following dialog is displayed.
16. Press Y to close the PXESelection Utility.
Configuring Emulex mezzanine card
7-85
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
