17. If the Personality is iSCSI, set up iSCSI parameters according to the
next step.
18. Press Ctrl and S when the following prompt was displayed.
iSCSISelect Utility starts.
(Only when iSCSI is selected in Personality setting on one of the CNA
products, the line of iSCSI Initiator BIOS is indicated.
Only when FCoE is selected in Personality setting on one of the CNA
products, the line of FCoE BIOS is indicated.)
Note: When the following message is indicated, press Enter.
19. iSCSISelect Utility is displayed. Set up the iSCSI Initiator Name for the
replaced card corresponding with ones for the failed card that you
recorded in the previous procedures.
20. Select Save, and then press Enter.
7-86
Configuring Emulex mezzanine card
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
