ID Message
Operation for which an audit log is
collected
01010001
"Failed to complete the request.
Accept:xxx"
When a user performs an operation for
setting Audit event type to StartStop
asynchronously and the operation fails
Table 9-4 List of audit log messages (ConfigurationAccess)
ID Message
Operation for which an audit log is
collected
01003000
"Requested to set the scheduling mode
of the PCI device. Accept:xxx
Slot#:xxx Port#:xxx PCI#:xxx
Value:xxx"
When HvmSh and so on is used to request
change of the scheduling mode of an PCI
device and the request is accepted
01003002
"Set the scheduling mode of the PCI
device. Slot#:xxx Port#:xxx PCI#:xxx
Value:xxx"
When the LPAR manager screen is used to
request change of the scheduling mode of an
PCI device and the request succeeds
01003003
"Failed to set the scheduling mode of
the PCI device. Slot#:xxx Port#:xxx
PCI#:xxx Value:xxx"
When the LPAR manager screen is used to
request change of the scheduling mode of an
PCI device and the request fails
01003004
"Set the LPAR manager system time.
Value:xxx"
When HvmSh and so on is used to request
change of the LPAR manager system time
and the request immediately succeeds
01003006
"Set the LPAR manager system time.
Value:xxx"
When the LPAR manager screen is used to
request change of the LPAR manager system
time and the request succeeds
01003007
"Failed to set the LPAR manager system
time. Value:xxx"
When the LPAR manager screen is used to
request change of the LPAR manager system
time and the request fails
01003008
"Set the time zone of the LPAR
manager. Value:xxx"
When HvmSh and so on is used to request
change of the time zone of the LPAR manager
and the request immediately succeeds
0100300A
"Set the time zone of the LPAR
manager. Value:xxx"
When the LPAR manager screen is used to
request change of the time zone of the LPAR
manager and the request succeeds
0100300B
"Failed to set the time zone of the
LPAR manager. Value:xxx"
When the LPAR manager screen is used to
request change of the time zone of the LPAR
manager and the request fails
0100300C
"Requested to set the LP ID.
Accept:xxx Value:xxx"
When HvmSh and so on is used to request
change of the LP identifier (LP ID) and the
request is accepted
0100300E "Set the LP ID. Value:xxx" When the LPAR manager screen is used to
request change of the LP identifier (LP ID)
and the request succeeds
0100300F "Failed to set the LP ID. Value:xxx" When the LPAR manager screen is used to
request change of the LP identifier (LP ID)
and the request fails
9-60
Messages
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
To Next Page
Loading...
