Hitachi Compute Blade 500 Series - Page 295

ID
Operation
category
Recording trigger Message
Channel:xxx Method:xxx
0807 Failure on requesting
switch module
operation.
On Switch module N, failed to
requested operation.
Channel:xxx Method:xxx
0808 Request of server blade
operation.
On Server blade N, requested
operation. Channel:xxx Method:xxx
0809 Failure on requesting
server blade operation.
On Server blade N, failed to
requested operation.
Channel:xxx Method:xxx
1800 Authentication Login to system
console.
Logged in to the System Console.
Username:xxx Session ID:xxx
Source IP address:xxx
1801 Failure on logging in to
system console.
Failed to login to the System
Console. Username:xxx Source IP
address:xxx Cause:xxx
1802 Logout from system
console
Logged out from the System
Console. Username:xxx Session
ID:xxx
Source IP address:xxx Cause:xxx
1803 Login to system Web
console.
Logged in to the System Web
Console. Username:xxx Session
ID:xxx
Source IP address:xxx
1804 Failure on logging in to
system Web console.
Failed to login to the System Web
Console. Username:xxx Source IP
address:xxx Cause:xxx
1805 Logout from system
Web console
Logged out from the System Web
Console. Username:xxx Session
ID:xxx
Source IP address:xxx Cause:xxx
1806 Failure on logging in to
system console or
system Web console.
Failed to login to the Console.
Cause:xxx
1810 Disconnect server blade
from BMC session.
On Server blade N, disconnect from
the BMC Session.
Channel:xxx Category:xxx
Value:xxx
1811 Failure on disconnecting
server blade from BMC
session.
On Server blade N, failed to
disconnect the BMC Session.
Channel:xxx Category:xxx
Value:xxx
1812 Login after the
password expiration
Permitted to log in to the Console
(for changing password).
Username:xxx Cause:xxx
Functional detail
2-271
Hitachi Compute Blade 500 Series Management Module Setup Guide