Hitachi Compute Blade 500 Series - Page 107

• Assign firmware to Server Blade (Selecting LPAR manager F/W version)
Table 2-101 Items in Assign firmware to Server Blade (Selecting LPAR
manager F/W version)
Item Description
Server Blade No. Shows the target server blade to assign LPAR
manager firmware.
LP firmware version pull down
list
Selects an LPAR manager firmware version.
Table 2-102 Action button at the bottom
Item Description
Next Confirms the LPAR manager firmware version and goes to the Assign
firmware to Server Blade (Operating LPAR manager configuration
information).
Cancel Cancels the settings and closes the Assign firmware to Server Blade
(Selecting LPAR manager F/W version) dialog box.
Tip: In SMP configuration, settings for the primary server blade are
applied. If a non-primary server blade is selected, the settings are shown
but LPAR manager will not operate with those setting values.
• Assign firmware to Server Blade (Operating LPAR manager configuration
information)
Operating the Web Console
2-97
Hitachi Compute Blade 500 Series Web Console User's Guide