Note: The values of following items cannot be set/changed while an LPAR
manager is running.
•
Logical Partitioning
• IP Address
• Subnet Mask
• Default Gateway
In addition, use HVM Navigator or LPAR manager screen to set the items
which are not supported by web console.
Tip: [Management module firmware version A0180 or later]
When LPAR manager address is set to 0.0.0.0, subnet mask and default
gateway will be also set to 0.0.0.0. LPAR manager is not available when
LPAR manager address is set to 0.0.0.0.
Tip: In SMP configuration, settings for the primary server blade are
applied. If a non-primary server blade is selected, the settings are shown
but LPAR manager will not operate with those setting values.
Table 2-110 Items in LP Settings (Editing)
Item Description
Logical
Partitioning
Enabled radio
button
Sets Logical Partitioning enable.
Disabled radio
button
Sets Logical Partitioning disable.
IP Address text box Sets IPv4 address used by LPAR manager.
The format of IPv4 is (xxx.xxx.xxx.xxx).
(xxx: a figure between 0 and 255)
2-102
Operating the Web Console
Hitachi Compute Blade 500 Series Web Console User's Guide
To Next Page
Loading...
