Hitachi Compute Blade 500 Series - Page 129

Item Description
2. Shows the information of each port or connected device.
Table 2-131 Action button at the bottom
Item Description
Confirm Shows the boot order settings confirm dialog box.
Cancel Release the settings; go back to the LPAR information dialog box.
• HBA boot settings (Configure)
[Management module firmware version A0125 or later]
With server blade model CB 520X, this setting is not available.
See HITACHI Gigabit Fibre Channel Adapter User's Guide (BIOS/EFI
Edition) for details of each setting and available values. When the target
HBA is in shared mode, Connection Type and Data Rate cannot be
changed. If you need to change them, change to the dedicated mode
temporarily.
• HBA boot settings (Confirm)
[Management module firmware version A0125 or later]
With server blade model CB 520X, this setting is not available.
Operating the Web Console
2-119
Hitachi Compute Blade 500 Series Web Console User's Guide