Hitachi Compute Blade 500 Series - Page 164

Table 2-177 Action button at the bottom
Item Description
Edit Edits Optional Physical WWNs. Follow instructions shown in the edit dialog box
to type an Optional Physical WWN.
Initialize Restores the Optional Physical WWN to the initial factory value.
If you initialize the Optional Physical WWN when server blades are switched
due to N+M cold standby, the same Optional Physical WWN may be created.
Make sure not to have the same Optional Physical WWN when initializing it.
Make sure to change settings for Compute Blade, SAN, and ServerConductor/
Blade Server Manager when initializing the Optional Physical WWN.
Close Closes this dialog box.
Default Physical WWN
When the primary server blade is selected, Default Physical WWN information
of all server blades in SMP configuration is shown.
Table 2-178 Default Physical WWN items
Item Description
Table heading Shows the server blade number and mezzanine card number
and name.
Port Shows port numbers.
World Wide Port Name Shows World Wide Port Names.
2-154
Operating the Web Console
Hitachi Compute Blade 500 Series Web Console User's Guide