When the primary server blade in SMP configuration is selected, LP version,
LP Model, and Upper bound of version for LP show information of all server
blades in SMP configuration.
Table 2-41 Settings tab items for server blades in SMP configuration
Item Description
Power AC recovery Power ON:
Powers on the server blade when the
power is supplied to the server chassis.
Power OFF:
Remains the server blade in power-off
when the power is supplied to the
server chassis.
Last state:
Returns the state of the server blade to
that in the last time when the server
chassis is powered off.
Recovery wait time When the operation after power
recovery is Power ON or Last state,
the wait time for the server blade to be
powered on from 0 up to 60 minutes.
Power On suppression Restricted: Power ON to the server
blade is restricted. This temporarily
occurs in server blades, active and
standby, when N+M cold standby
switches server blades.
Power ON available: Power-on
restriction is disabled.
Smart Configure Status Smart Configure is in operation. Shows
one of the following:
No Information; In Progress; Not
Configured; Configured
N+M cold standby Enables and Disables N+M cold
standby: Enabled/Disabled.
With Enabled, N+M cold standby is
built, and Smart Configure is
automatically performed once. Smart
Configure is also automatically
performed when the server chassis is
powered on or a server blade is
inserted.
WWN type Select WWN for the fibre channel
adapter on the server blade to use:
default physical or optional physical.
With N+M cold standby enabled, WWN
type is fixed to Optional Physical WWN.
MAC type Select MAC address for the LAN
adapter on the server blade to use:
default physical or optional physical,
Operating the Web Console
2-43
Hitachi Compute Blade 500 Series Web Console User's Guide
To Next Page
Loading...
