Hitachi Compute Blade 500 Series - Page 54

Item Description
regardless of N+M cold standby
settings.
LP Logical Partitioning Shows whether or not to operate LPAR
manager on the server blade.
Enabled: Performs LPAR manager.
Setting details are shown in the
LPAR
tab on page 2-87.
Disabled: Normal OS starts without
performing LPAR manager.
Server blade0 LP
version
Shows the LPAR manager firmware
version assigned to the server blade in
LP mode. For Basic-mode server
blades, "--------" is shown.
LP Model Shows an LPAR manager model.
Upper
bound of
version
Shows the latest version of LPAR
manager firmware available.
Server blade2 LP
version
Shows the LPAR manager firmware
version assigned to the server blade in
LP mode. For Basic-mode server
blades, "--------" is shown.
LP Model Shows an LPAR manager model.
Upper
bound of
version
Shows the latest version of LPAR
manager firmware available.
Table 2-42 Action buttons at the bottom
Item Description
Show LP
settings
[Management module firmware version A023X or earlier]
Shows the LPAR manager settings dialog box. For details of how to
use the dialog box, see
LPAR tab on page 2-87.
[Management module firmware version A0240 or later]
Moves to the LPAR manager tab on page 2-72. The LPAR manager
tab on page 2-72
displays the LP settings.
Edit Server
Blade settings
Sets the server blade operation: Smart Configure setting at the power
recovery.
2-44
Operating the Web Console
Hitachi Compute Blade 500 Series Web Console User's Guide